🇺🇸Please Note: We currently ship orders nationwide within the United States.

How to Secure Figurines on a Shelf

To secure figurines on a shelf, clean the base and the shelf, press two to four pea-size beads of museum gel under each figurine, and leave it alone for 30 to 60 minutes. Once set, ZYGLUE™ Museum Gel helps keep figurines from sliding or tipping from everyday bumps and vibration, and it lifts off again when you want to rearrange the shelf.

ZYGLUE clear museum gel 1 Pack with one 4.2 oz jar

Why do figurines need help staying put?

Figurines are often small, light and top-heavy, with a narrow base or a pose that leans to one side. On a smooth shelf, a light knock can be enough to send one sliding into its neighbor or over the edge. Collectors deal with this all the time: a door closes, someone dusts the cabinet, a cat explores the top shelf, and a favorite piece ends up on its side.

A small amount of clear museum gel under each piece gives it a better hold on the shelf, so everyday bumps are less likely to move it.

Figurine putty or museum gel: which should you use?

Many people search for "figurine putty" because putty is the best-known option. Museum gel does the same job as museum putty or museum wax. Because ZYGLUE is clear, it is less visible under glass, crystal and light-colored porcelain, which is handy when a figurine stands on a glass shelf and you can see underneath it.

The user manual says the gel holds by forming a micro-vacuum between the gel and a smooth surface, not by stickiness. It is removable and reusable, and the gel itself is clear and odorless. For a full comparison, see Museum Gel vs Museum Putty vs Museum Wax.

How do you secure a figurine with museum gel?

  1. Clean first. Make sure the figurine's base and the shelf are clean, dry and free of dust or oil.
  2. Use a small amount. Take a pea-size piece with clean hands or the spatula. Two to four pea-size beads hold most small items. Too much gel reduces performance. Use more beads for a larger or heavier base.
  3. Apply and press. Put the gel on the bottom of the figurine, set it in place and press down gently. Keep the gel away from the edges so it does not squeeze out.
  4. Let it set. Leave it undisturbed for 30 to 60 minutes. It holds after about 30 minutes and reaches full hold after 60 minutes.

Then wiggle the figurine gently to check the hold. The edges may spread slightly after a few hours; trim any excess with the spatula or your fingers.

Tips for small or oddly shaped figurines

  • For a tiny base, use smaller beads under the flattest part of the base. Too much gel reduces performance and can squeeze out.
  • For a figurine that stands on two feet or a ring-shaped base, place a bead under each contact point.
  • Very heavy or irregular-shaped pieces may not hold securely and can shift or fall, so display those another way.
ZYGLUE museum gel jar beside a white bust on a display shelf

Which figurines and shelves work best?

ZYGLUE holds figurines, statues, trophies, antiques and collectibles on shelves, mantels, china cabinets, display cases and side tables. It works best when both the base and the shelf are smooth and sealed:

  • Best on: glass, crystal, glazed ceramic, porcelain, metal, sealed marble and granite, and acrylic.
  • Test a small hidden spot first: finished or polished wood, painted, lacquered or plastic surfaces, and antique finishes. This matters for older figurines and for antique cabinets.
  • Not for: unfinished wood, raw or porous stone, paper, cork or fabric. The manual warns the gel may leave permanent oil stains on porous materials.

Use it on horizontal surfaces only. Wall shelves are fine if the shelf itself is flat and level, but never put the gel on a wall, a hanging frame or any vertical or angled surface.

How do you look after a figurine display?

  • Inspect every 1 to 2 months, especially when the seasons or room temperature change.
  • Keep shelves cool. The gel softens above 40 °C (104 °F). Keep it out of direct sun and hot areas, where it can lose grip and leave residue.
  • Rearrange the right way. Twist the figurine gently and lift; do not pull straight up. Peel or roll leftover gel off by hand and wipe with a dry cloth. For tougher marks, use warm water or an alcohol-based wipe.
  • Reuse the gel when you move pieces around.
  • Keep the jar away from children and avoid eye contact.
ZYGLUE museum gel 1 Pack box and jar with dimensions

Which ZYGLUE pack should you get?

For one shelf or a single cabinet of figurines, the ZYGLUE 1 Pack is a good start: one 4.2 oz (120 g) jar with its own spatula. Larger collections can step up to the 2 or 3 Pack.

  • 1 Pack: 1 jar, 4.2 oz (120 g), 1 spatula
  • 2 Pack: 2 jars, 8.4 oz (240 g), 2 spatulas
  • 3 Pack: 3 jars, 12.6 oz (360 g), 3 spatulas

Frequently asked questions

Is museum gel the same as figurine putty?

It does the same job as museum putty or museum wax. Because it is a clear gel, it is less visible under glass and crystal.

How much gel do I need per figurine?

Two to four pea-size beads hold most small items. Use more beads for a larger or heavier base.

Can I use it on antique figurines or cabinets?

Test a small hidden spot first on antique finishes, finished wood, paint, plastic or lacquer before you use it on the whole display.

How do I remove it?

Twist the item gently; do not pull straight up. Roll any leftover gel off with your fingers.

Is it safe?

The safety data sheet classifies the gel as non-hazardous. Keep it away from children and avoid eye contact.

Buy ZYGLUE Museum Gel from SN International

ZYGLUE is SN International's own brand of clear museum gel, a simple way for collectors to keep figurines in place. You can buy it at retail as a guest or with a free account. Businesses, gift shops and resellers can apply for a business account to see member pricing. Orders ship nationwide from our California warehouse, and real people answer the phone Monday to Friday. See all three packs on the ZYGLUE brand page.